Filter
Top Products
Installing a drive in bay 1 or bay 2
To install a drive in bay 1 or bay 2, follow these steps:
1. Remove the cover. See “Removing the cover” on page 10.
2. Remove the front bezel by pressing downward on the plastic tabs 1 and
pulling the bezel as shown.
3. Remove the static shield from the drive bay by using a flat-blade screwdriver
to gently pry it loose.
4. Remove the plastic panel in the bezel for bay 1 or 2 by squeezing the plastic
tabs that secure the panel on the inside of the bezel.
Chapter 1. Installing options 17