Filter
Top Products
SST-2450 Wireless Modem User’s Manual Ver1.5, Feb /2003, OMH-030-10, ---17
5.2. SST-2450 Settings
When setting the SST-2450, you should first use a wire to connect the SET
and GND pins. Quickly power off and power on the SST-2450, then launch the
setting software program. There are only 3 steps required to make your settings.
1. Open a Serial Port.
2. Setting the operating mode.
3. Exit the program.
When setting the operating mode, please refer to the following steps:
When you set the SST-2450, you should never use the following
settings:
SST-2450 (A) SST-2450 (B)
Half-duplex Half-duplex
Master Slave
These settings will cause the SST-2450 set as the Master to be
always on high power status and will cause the SST-2450 to fail. Please
note that this situation isn’t covered by our warranty.
The correct settings are as follows:
SST-2450 (A) SST-2450 (B)
Full-duplex Full-duplex
Master Slave
or
SST-2450 (A) SST-2450 (B)
Half-duplex Half-duplex
Slave Slave
If you have a SST-2450 Network (i.e. more than 2 SST-2450 devices), you
are only able to use the following specific setting for all of your SST-2450
devices:
Half-duplex
Slave