InFocus IN112A Projector User Manual


 
28
Lamp...
Programmed Dimming: When enabled, Program
med Dimming enhances con-
trast ratios in dark scenes and disables Lamp Low Power. Programmed Dim-
ming will impact lamp life and system noise performance. Programmed
Dim
ming works in conjunction with the lamp. If Lamp Low Power is enabled,
Programmed Dimming is unavailable.
Lamp Low Power:
toggles between on and off. Turn it on to lower the light
output of the lamp. This also lowers the fan speed, making the projector qui-
eter.
OSD Setup...
Language: allo
ws you to select a language for the onscreen display.
Menu Position: allo
ws you to change the position of the On Screen Display
items.
Menu Transparency:
allows you to change how much of the projected image
behind the menu you can see. As the value increases, more of the image
behind the menu is visible.
Show Messages: di
splays status messages (such as “Searching”) in the lower-
left corner of the screen.
PIN Settings
PIN Protect: The PIN (p
ersonal identification number) feature allows you to
password protect your projector. Once you enable the PIN feature, you must
enter the PIN before you can project an image. Use the Up/Down/Left/Right
arrows buttons on the remote or keypad to set a 4-button press sequence. If
you enter an incorrect PIN 3 times in succession, the projector will automat-
ically shut down. If you lose or forget your custom PIN, contact InFocus
Techn
ical Support.
To enter the PIN at projector startup:
Power up the projector. The “Enter PIN” dialog box appears after the startup
screen. Enter the PIN. Use the Up/Down/Left/Right arrows buttons on the
remote or keypad to enter the correct 4-button press sequence. See the
description above for instructions.
To change the PIN:
Select “Change PIN...” in the Advanced Menu > Setup > PIN settings menu.
Ente
r the existing PIN. Enter the new PIN.
Power
Power Saving Mode: When
the Power Saving Mode is On and the projector is
in standby (powered off but connected to AC power), external audio and the
Monitor Out function will not work.
AC Power On: When
this feature is enabled, the projector automatically
turns on when power is connected. This allows control of ceiling mounted
projectors with a wall power switch.
Instant Power On: When
this feature is enabled and it has been less than 1
minute since the projector was powered down, you can turn the projector
back on immediately. When this feature is disabled, you will need to wait for
the projector lamp to completely cool before restarting the projector.
Eco Blanking: When this feature is enabled and no video source is sensed,
70% of lamp power is saved and no image is shown. When the video source is
again applied, the image is shown immediately.
Source
Auto Source:
When this feature is On, the projector automatically finds the
active source, checking the selected Power-up Source first. When this feature
is Off, the projector defaults to the source selected in Power-up Source. To
display another source, you must manually select one by pressing the Source
button on the remote or keypad and selecting one from the displayed Source
menu.
Power-up Source:
determines which source the projector checks first for
active video during power-up.
Search Screen:
allows you to display a blank screen instead of the default
screen at startup, and when no source is detected.