Filter
Top Products
26
Important!
z Continued use of the projector after dust has accumulated around the intake vents
can cause overheating of internal components and lead to malfunction.
z Certain operating conditions also can cause dirt and dust to accumulate around the
projector's exhaust vents on the front. If this happens, use the same procedure as
that described above to clean the exhaust vents.
Caution
Continued use of a lamp that has passed its lamp life increases the risk of the lamp
rupturing. Replace the lamp with a new one as soon as possible after the replacement
message appears.
z The light source lamp is a consumable item. The average life of a lamp is approximately
2000 hours. After 2000 hours, a message appears to alert you to the need of lamp
replacement. However, note that the characteristics of a particular lamp or lamp operating
conditions can cause the lamp to start to go dim or even fail before the message
appears.
To check the current lamp use time
1
Press the [MENU] key to display the setup menu.
2
Press the [T] key to select the “Operational
Info” main menu.
z The “Lamp Time” sub-menu item shows the
number of hours that the current lamp has been
used.
3
Press the [MENU] key to exit the setup
menu.
Replacing the Lamp