Filter
Top Products
IN3118HD User’s Manual
– 38 –
LED Error Messages
ERROR CODE MESSAGES POWER LED LAMP / READY LED TEMP LED
Powered on Solid Green Solid Red OFF
Powering up Solid Green Flashing Red OFF
Cooling down Solid Green Flashing Red OFF
Over Temperature OFF OFF Solid Red
Thermal Break Sensor error Flashes Green 4x Flashes Green 4x OFF
Lamp error/Color wheel control error Flashes Green 5x OFF OFF
Lamp End of lamp life detected Flashes Green 5x Flashes Green 3x OFF
Burner Fan error Flashes Green 6x Flashes Green 1x OFF
Lamp Fan error Flashes Green 6x Flashes Green 2x OFF
Power Fan error Flashes Green 6x Flashes Green 3x OFF
DMD Fan error Flashes Green 6x Flashes Green 4x OFF
Case Open Flashes Green 7x OFF OFF
DMD error/Ignition failed Flashes Green 8x OFF OFF
Color wheel error Flashes Green 9x OFF OFF
In the event of an error, please disconnect the AC power cord and wait for one (1) minute before re-
starting the projector. If the POWER or LAMP LEDs are still blinking or the TEMP LED is lit, contact
InFocus Technical Support at www.infocus.com/support
.
Image Problems
Problem: No image appears on the screen
1. Verify the settings on your notebook or desktop PC.
2. Turn off all equipment and power up again in the correct order.
3. Many laptops do not automatically turn on their external video port when a projector is
connected. Usually a key combination like FN + F8 or CRT/LCD key turns the external
display on and off. Locate a function key labeled CRT/LCD or function key with a monitor
symbol. Press FN and the labeled function key simultaneously.
Problem: The image is blurred
1. Adjust the Focus on the projector.
2. Press the Auto Image button on the remote control or the Re-sync button on the keypad.
3. Ensure the projector-to-screen distance is within the 10-meter (33-feet) specified range.
4. Check that the projector lens is clean.
Problem: The image is wider at the top or bottom (trapezoid effect)
1. Position the projector so it is as perpendicular to the screen as possible.
2. Use the Keystone button on the remote control or projector to correct the problem.
Problem: The image is reversed
Check the Projection setting on the Setup >> Basic menu of the OSD.