InFocus IN3924 Projector User Manual


 
34
2
The Tools page allows you to manage the projector, configure the LAN control
settings and remotely access the network operations of this projector.
iii
ii
i
i. This area is only used with a Crestron Control System. Please contact Creston
or refer to the Crestron user manual for setup information.
ii. This area is used for naming the projector
, associating it with a particular loca-
tion, assigning a responsible party to
it, and adjusting network settings.
iii. This area is used to set User and Admin p
asswords. When password protec-
tion is enabled, unauthorized changes to
the projector configuration will be
avoided.
To prevent errors, only enter alphanumeric characters on the Tools page.
After configuring the settings, press the Send button and the data will be
saved in the projector.
•Press exit to go back to the Crestron remote network operation page.
Please pay attention to the input length and character limitations (including
ch
aracter and punctuation restrictions) listed below:
Category Item Input-Length
Maximum Number of
Characters
Crestron Control
/ > < $ % + \ ' " are prohibited.
IP Address 15
IP ID 2
Port 5
Projector
Projector Name 10
Location 9
Assigned To 9
Network
Configuration
DHCP (Enabled) (N/A)
IP Address 15
Subnet Mask 15
Default Gateway 15
DNS Server 15
User Password
Enabled (N/A)
New Password 20
Confirm 2
Admin Password
Enabled (N/A)
New Password 20
Confirm 20