Filter
Top Products
6
PJLink command
PJLink command
Commands Control Description Parameter or Response
POWR Power Contorol
0 = Standby
1 = Power On
POWR ? Power Status inquiry
0 = Standby
1 = Power On
2 = Cool Down
INPT Input Source selection
11 = COMPUTER IN 1
12 = COMPUTER IN 2
13 = BNC
21 = COMPONENT
22 = S-VIDEO
23 = VIDEO 1
24 = VIDEO 2
31 = HDMI
32 = DVI-D
INPT ? Input Source inquiry
11 = COMPUTER IN 1
12 = COMPUTER IN 2
13 = BNC
21 = COMPONENT
22 = S-VIDEO
23 = VIDEO 1
24 = VIDEO 2
31 = HDMI
32 = DVI-D
AVMT AV Mute
30 = BLANK off
31 = BLANK on
AVMT ? AV Mute inquiry
30 = BLANK off
31 = BLANK on
ERST ? Error Status inquiry
1st byte: Refers to Fan error; one of 0 to 2
2nd byte: Refers to Lamp error; one of 0 to 2
3rd byte: Refers to Temperature error; one of 0 to 2
4th byte: Refers to Cover error; one of 0 to 2
5th byte: Refers to Filter error; one of 0 to 2
6th byte: Refers to Other error; one of 0 to 2
The mearning of 0 to 2 is as given below
0 = Error is not detected; 1 = Warning; 2 = Error
This projector is equipped with PJLink
TM
Class 1 protocol.
Refer to the following table to control the projector using PJLink
TM
protocol
commands.