Filter
Top Products
Quick Installation Guide
2
Rear Panel
Installation
1) Connect the projector’s antenna, and connect the VGA cable to the
LiteShow VGA connector. Turn the projector on.
2) Turn on LiteShow. The LiteShow instructions below will display on the
projector when LiteShow is ready for use.
Power Jack
VGA Connector
RJ-45
Antenna
Audio
Factory Reset button
Antenna
To b eg in pro je ct ing ove r th e LA N, th e LI TE SH OW a pp li cat io n mu st b e in st al le d a nd r un ni ng o n your c omp ute r.
This application is needed to manage the communication between your computer and the LITESHOW module.
INSTRUCTIONS
1) Download and install the LITESHOW application, if not already installed on your computer
a) Connect the LITESHOW module to a display (and to a network, if desired).
b) Turn on the LITESHOW module and display. The LITESHOW splash screen should appear within one minute.
c) You must be connected to the LITESHOW module through a wired or wireless LAN. For wireless LAN, connect
to the wireless network using the same SSID as shown on the display.
d) Enter the IP address displayed on the display into your web browser.
e) Lo gin as NONE and select SOFTWARE DOWNLOAD.
f) Download the LITESHOW application.
2) Run the LITESHOW application
a) At the Acc ess Point prompt, select the appropriate wireless connection to the LITESHOW module or choose
SKIP for a wired LAN connection.
b) Select the LITESHOW module from the Device List.
c) Enter the Lo gin Code, if enabled.
3) Begin presenting
Server IP: 192.168.100.10
Re solution: 1280 x 800
Version: 1.0.0.0
SSID:
LiteShow3
Channel: 11
Security: None
LOGIN CODE: 1234