InFocus LP225 Network Card User Manual


  Open as PDF
of 4
 
Note: Specified commands and values apply to the LP225 with version 1.10 software or higher. The version number of the
software is the first number listed in the upper right corner of the on-screen menu. Command values for LP225s with earlier
software versions may vary. If your LP225 does not have version 1.10 software or higher, go to the Software/Downloads
page to
download and upgrade the projector software.
For absolute command value ranges of 0 - 1, 0 = "Off" and 1-9999 = "On" unless otherwise noted.
Range
Data Source
(Computer)
Video Source
Function Command
Min-Max, Initial Value Min-Max, Initial Value
Power (write only) ("PWR") N/A N/A
Brightness ("BRT") 0-32,16 0-32,16 or 14
Tint ("TNT") 0-32,16 0-32,16
Contrast ("CON") 0-32,16 0-32,18 or 16
ColorTemp ("TMP") N/A N/A
Saturation ("CLR") N/A 0-32,16
Optimize ("OPT") N/A N/A
VideoFmt ("VSU") N/A 0-6,0
Volume ("VOL") 0-80,40 0-80,40
Balance ("BAL") 0-31,16 0-31,16
Treble ("TRB") 0-14,7 0-14,7
Bass ("BAS") 0-14,7 0-14,7
Fade ("FAD") 0-31,16 0-31,16
Ambiance ("AMB") 0-37,19 0-37,19
Mute ("MTE") 0-1,0 0-1,0
Manual Tracking ("MTS") 0-63,32* N/A
Manual Sync ("MSS") 0-19,10* N/A
Horiz Position ("HPS") 0-63,32* N/A
Vertical Position ("VPS") 0-63,32* N/A
Auto Image ("AIM") 0-1,1 N/A
Resize ("ARZ") 0-1,1 0-1,1
Freeze ("FRZ") 0-1,0 0-1,0
Language ("LAN") 0-3,0 0-3,0
Ceiling ("CEL") 0-1,0 0-1,0
Rear Project ("REA") 0-1,0 0-1,0
Reset ("RST") 0-1,0 0-1,0
Auto Source ("ASC") 0-1,0 0-1,0
Default Source ("DSC") 0-1,0 0-1,0
Blank Screen ("BSC") 0-1,0 0-1,0
Menu Position ("MPS") 0-4,0 0-4,0
Standby Time ("SBT") N/A N/A
Display Messages ("DMG") N/A N/A
Display Startup Screen ("DSU") N/A N/A
Standby Mode ("STB") 0-1,0 0-1,0
Source ("SRC") 0-1,0
0 = computer
1 = video
0-1,0
0 = computer
1 = video
Bulb Clock (read only) ("LMP") 0-9999,0 0-9999,0
*Software dynamically changes range based on the signal received.
 previous