Filter
Top Products
6
7” Wifi Android
TM
Tablet
www.insigniaproducts.com
(iii) L'utilisateur doit également être informé que les radars hight-puissance sont désignés comme
utilisateurs principaux (à savoir les utilisateurs prioritaires) des bandes 5250-5350 MHz et que ces radars
pourraient cause des interférences et / ou à l'appareil LE-LAN;
RSS-102 Statement
This equipment complies with Industry Canada radiation exposure limits set forth for an uncontrolled
environment.
Cet équipement est conforme à l'exposition aux rayonnements Industry Canada limites établies pour un
environnement non contrôlé.
Specific Absorption Rate (SAR) Certification Information
Your wireless mobile device is a radio transmitter and receiver. It is designed and manufactured not to
exceed the exposure limits for Radio Frequency (RF) energy set by the Federal Communications
Commission (FCC) of the U. S. Government.
These FCC RF exposure limits are derived from the recommendations of two expert organizations: The
National Council on Radiation Protection and Measurement (NCRP) and the Institute of Electrical and
Electronics Engineers (IEEE). In both cases, the recommendations were developed by scientific and
engineering experts drawn from industry, government, and academia after extensive reviews of the
scientific literature related to the biological effects of RF energy.
The RF exposure limit set by the FCC for wireless mobile devices employs a unit of measurement known as
the Specific Absorption Rate (SAR). The SAR is a measure of the rate of absorption of RF energy by the
human body expressed in units of watts per kilogram (W/kg). The FCC requires wireless devices to comply
with a safety limit of 1.6 watts per kilogram (1.6 W/kg).
The FCC SAR limit incorporates a substantial margin of safety to give additional protection to the public
and to account for any variations in measurements.
SAR tests are conducted using standard operating positions accepted by the FCC with the mobile device
transmitting at its highest certified power level in all tested frequency bands. Although the SAR is
determined at the highest certified power level, the actual SAR level of the mobile device while operating
can be well below the maximum reported value. This is because the mobile device is designed to operate
at multiple power levels so as to use only the power required to reach the network. In general, the closer
you are to a wireless base station antenna, the lower the power output of the mobile device.
Before a new model mobile device is available for sale to the public, it must be tested and certified to the
FCC that it does not exceed the SAR limit established by the FCC. Tests for each model mobile device are
performed in positions and locations (e.g. near the body) as required by the FCC.
By typical operations, this mobile device has been tested and meets FCC SAR guidelines.
Use of other accessories may not ensure compliance with FCC RF exposure guidelines. The FCC has
granted an Equipment Authorization for this mobile device with all reported SAR levels evaluated as in
compliance with the FCC RF exposure guidelines.
SAR information on this and other model mobile devices can be accessed online on the FCC’s website
through http://transition.fcc.gov/oet/rfsafety/sar.html. To find information that pertains to a particular
model mobile device, this site uses the mobile device FCC ID number, which is usually printed somewhere
on the case of the mobile device.
Once you have the FCC ID number for a particular mobile device, follow the instructions on the website
and it should provide values for typical or maximum SAR for a particular mobile device. Additional SAR
information can also be obtained at http://www.fcc.gov/encyclopedia/
specific-absorption-rate-sar-cellular-telephones.
IFETEL Statement
La operación de este equipo está sujeta a las siguientes dos condiciones:
1) es posible que este equipo o dispositivo no cause interferencia perjudicial y
2) este equipo debe aceptar cualquier interferencia, incluyendo la que pueda causar su propia
operación no deseada.
NS-15AT07_14-1199_IMP_INFO_V2_ENG.fm Page 6 Monday, November 24, 2014 11:09 AM