Filter
Top Products
6
www.insigniaproducts.com
Setting up the shredder
To set up the shredder:
1 Position the shredder head over the basket.
2 Place the shredder head on the basket so that it solidly rests on the
basket edges.
Warning
Crosscut shredders have very sharp exposed blades on the
underside. Use care when mounting the shredder on the
wastebasket.
Caution
The shredder should not be plugged in during assembly.
Note
The following illustrations are for information purposes only.
Your actual shredder may look somewhat different than the
shredder shown.
Note
Always make sure that these two labels are aligned on the same
side of the shredder when you place the shredder head onto the
basket. This shredder has a safety interlock which prevents it
from operating unless the shredder head is placed on the basket
correctly.
NS-PS06CC_14-0085 MAN_V1_ENG.fm Page 6 Tuesday, March 4, 2014 2:14 PM