Filter
Top Products
14 Hardware Installation and User’s Guide
Hardware Installation
Figure 2-1. IIR Controller Component Layout
2.2.2 Installing the IIR Controller
1. Power-off the computer system.
2. Disconnect power cord(s) and remove the system cover.
3. Install the IIR controller into an available RAIDIOS-enabled PCI slot. See Figure 2-2.
Note:
The computer system (with RAIDIOS-enabled PCI slot) illustrated in Figure 2-2 may
not be representative of your system. Consult your system docs for the exact location of
the RAIDIOS-enabled PCI slot.
4. Connect one end of the SCSI cable to the on-board SCSI connector. Connect the other
end of the SCSI cable to the SCSI drives or drive enclosure.
Note:
Ensure that the end of the SCSI bus is properly terminated. See Section 2.4 in this
guide for termination details.
5. Replace the system cover and reconnect power cord(s).
167mm (6.57 inches)
56mm (2.20 inches)
J1B1
Flash Memory
I/O Processor
DS2A1
SDRAM
64Bit PCI Interface
(Requires a RAIDIOS
-
enabled PCI slot)