Filter
Top Products
6.3 Advance BIOS Features
CPU L1&L2 Cache Leave these items enabled since all the processors that can be installed on
this board have internal L2 cache memory
First Boot Device when system boot-strap first time detect decive
Second/ third boot device when system boot-strap first time detect device
Boot other Device if you enable this item the system will also search for other boot devices if it
fails to find an operating system from the first two locations.
Swap floppy drive if you have two diskette drives installed and you enable this item drive A
becomes drive installed and you enable this item drive A becomes drive B and drive B
becomes drive A
6.4 Advanced Chipset Features
DRAM Timing Selectable
BIOS auto detect by SPD Default: Manuel
CAS latency Time
Set up memory read order wait time Default: 2.5
Active to Pecharge Delay
Control DRAM running Pecharge delay time option Default:6
DRAM RAS –to CAS Delay
Control DRAM startup read and write order Default:3
Memory Frequence for
Memory frequecce enabled select DDR200/DDR266 Default: AUTO
System BIOS Cacheable
If enable system BIOS read cache Default: Disabled
Video BIOS Cacheable
If enable Video BIOS read cache Default: Disabled
Delayed Transaction
Enable ICH2 will be delayed Default: Disabled
Delayed prior to Thermal
Enable system detect DRAM temperature time Default: 16min
AGP Aperture Size(MB)
Select AGP capability Default: 64MB
6.5 Integrated peripherals
On-chip primary/ Secondary PCI IDE
Chipset inside the first/ second channel of PCI IDE interface Default: Enabled
IDE Primary / Secondary Master slave PIO
The first/ second IDE primary master/ primary slave control PIO
Mode Default: Auto
USB Controller
Setup USB controller Default: Enabled
USB Keyboard Support
Setup Support USB keyboard Default: Disabled
AC97 Audio
If use AC97 sound chipset Default: Audio
Init Display First
When boot-start the first time delect device Default: PCI slot
Onboard FDC Controller
Setup onboard FDC controller Default: Enabled
Onboard serial port ½
Setup onboard serial port ½ Default: 3F8/IRQ4
UART Mode select
Setup UART mode select Default: Normal
Onboard paralled Port