Filter
Top Products
- 34 -8S661FXM-RZ Motherboard
English
CPU Clock (MHz)
100~355 Select CPU Clock to 100MHz~355MHz.
If you use FSB400 Pentium 4 processor, please set "CPU Clock" to 100MHz.If you use FSB533
Pentium 4 processor, please set "CPU Clock" to 133MHz. If you use FSB800 Pentium 4
processor, please set "CPU Clock" to 200MHz.
Incorrect using it may cause your system broken. For power End-User use only!
DRAM Clock (MHz)
Please set DRAM Clock according to your requirement.
If you use DDR200 DRAM module, please set "DRAM Clock(MHz)" to 200. If you use DDR333
DRAM module, please set "DRAM Clock(MHz)" to 333.
Incorrect using it may cause your system broken. For power End-User use only!
AGP/PCI Clock Control
AUTO Set AGP/PCI clock automatically. (Default Value)
Manual Set AGP/PCI clock manually.
M Incorrect using it may cause your system broken. For power End-User use only!
AGP Clock (MHz)
Please set AGP Clock according to your requirement.
Incorrect using it may cause your system broken. For power End-User use only!
PCI Clock (MHz)
Please set PCI Clock according to your requirement.
Incorrect using it may cause your system broken. For power End-User use only!
If you wish to maximize the performance of your system, enable "Top Performance."
Disabled Disable this function. (Default Value)
Enabled Enable Top Performance function.
"Top Performance" will increase H/W working speed. Different system configuration (both H/W
component and OS) will effect the result. For example, the same H/W configuration might not run
properly with Windows XP, but works smoothly with Windows NT. Therefore, if your system is not
perform enough, the reliability or stability problem will appear sometimes, and we will recommend you
disabling the option to avoid the problem as mentioned above.
CMOS Setup Utility-Copyright (C) 1984-2004 Award Software
} Standard CMOS Features
} Advanced BIOS Features
} Integrated Peripherals
} Power Management Setup
} PnP/PCI Configurations
} PC Health Status
} Frequency/Voltage Control
Top Performance
Load Fail-Safe Defaults
Load Optimized Defaults
Set Supervisor Password
Set User Password
Save & Exit Setup
Exit Without Saving
ESC: Quit higf: Select Item
F8: Q-Flash F10: Save & Exit Setup
Time, Date, Hard Disk Type...
Top Performance
Disabled.........................[n]
Enabled..........................[ ]
hi: Move ENTER: Accept
ESC: Abort
Top Performance