Filter
Top Products
Technical Reference
39
Upgrading the BIOS
CAUTION
Not updating the system boot block when updating the BIOS may result in an untested system
configuration. Some BIOS upgrade releases may require updating the system boot block. To find
out if you need to update the boot block, go to the Intel website at:
http://www.developer.intel.com/design/motherbd
1. Boot the computer with the BIOS upgrade diskette in drive A. Press
<Enter> to go to the
Main menu. The flash memory update utility screen appears.
2. Select
Update flash memory area from a file. Press <Enter>.
3. Select Update System BIOS. Press <Enter>.
4. Use the arrow keys to select the correct
.bio file. Press <Enter>.
5. When the utility asks for confirmation that you want to flash the new BIOS into memory,
select
Continue with programming. Press <Enter>.
6. When the utility displays the message
Reboot Warning, remove the diskette. Press
<Enter>.
7. As the computer boots, check the BIOS identifier (version number) to make sure the upgrade
was successful. If a logo appears, press
<Esc> to view the POST messages.
8. To enter the BIOS Setup program, press
<F2> when you see the message:
Press <F2> to Run SETUP
9. For proper operation, load the BIOS Setup program defaults. To load the defaults, press <F9>.
10. To accept the defaults, press
<Enter>.
11. In Setup, enter the settings you wrote down before beginning the BIOS upgrade.
12. To save the settings, press
<F10>.
13. To accept the settings, press
<Enter>.
14. Turn off the computer and reboot.
Recovering the BIOS
It is unlikely that anything will interrupt the BIOS upgrade; however, if an interruption occurs, the
BIOS could be damaged. The following steps explain how to recover the BIOS if an upgrade fails.
The following procedure uses recovery mode for the Setup program. See Chapter 3 for more
information on Setup modes.
NOTE
Because of the small amount of code available in the boot block area, there is no video support.
You will not see anything on the screen during this procedure. Monitor the procedure by listening
to the speaker and looking at the diskette drive LED.
1. Turn off the computer, disconnect the computer’s power cord, and disconnect all external
peripherals.
2. Remove the computer cover and locate the configuration jumper block (J7A1) (see Figure 1).