Filter
Top Products
Intel Desktop Boards D845GRG and D845GBV Product Guide
28
Removing the AGP Card
Follow these instructions to remove the AGP card from the RM:
1. Remove the screw (B) that secures the card’s metal bracket (A) to the chassis back panel.
2. Push back on the RM lever (D), as shown in Figure 9, until the retention pin (C) completely
clears the notch in the card.
3. Pull the card straight up (E).
OM10595
A
B
C
D
E
Figure 9. Removing the AGP Card
Connecting the IDE Cable
The Intel
®
boxed desktop board package includes an IDE cable. The cable connects two drives to
the desktop board. The cable supports the Ultra DMA-33 and ATA-66/100 transfer protocols.
Figure 10 shows the correct installation of the cable.
✏
NOTE
ATA-66/100 compatible cables are backward compatible with drives using slower IDE transfer
protocols. If an ATA-66/100 disk drive and a disk drive using any other IDE transfer protocol are
attached to the same cable, the maximum transfer rate between the drives may be reduced to that
of the slowest drive.