IOGear GHPB21 Network Card User Manual


 
If you plan to use this unit as a
NODE, not as a BRIDGE (refer to
the Network Terms for details):
1. Remove the HomePlug Bridge, the
power cord, the CAT5 cable and the
installation CD from the package.
2. Allocate a space for the adapter's
placement. Make sure you avoid the
places mentioned on the previous
page.
3. Make sure that your HomePlug bridge
is NOT CONNECTED TO THE
COMPUTER before you install the
driver.
4. Insert the installation CD. If CD does
not automatically load, run (CD Drive
Letter):\setup.exe.
5. Click Next.
Installation
8
(Note: When used as node, the bridge uses the same driver as the homeplug USB adapter.)