Filter
Top Products
Attach the Mounting Plate to the Projector
6
Attach the Mounting Plate to the Projector
1
Set the projector on a table with the bottom
side up.
CAUTION
: Use only the
hardware that is provided
with the LP 1000 Series
Ceiling Mount. Using
different hardware may
damage your projector.
2
Insert the 3 screws into the 3 quick release
sleeves (Figure 3).
3
Attach the screws and sleeves to the holes in
the projector as shown in Figure 3. Be careful
not to over-tighten the bolts.
4
Align the keyholes in the mounting bracket
with the screws in the projector. Slide the
mounting bracket until the quick release
sleeves are at the top of the keyhole slot.
5
Attach the 10/32 knurled knob to the projec-
tor in the location shown in Figure 3.
F
IGURE
3
Attach the mounting plate to the projector
quick release screws
knurled knob
goes here
quick release screw