Filter
Top Products
SP-CEIL-012
Page - 10 - Installation Manual
1. Install the two (2) conical spacers and two (2)
flat washers two, (2) hinge pin screws loosely
on both sides of the base box.
2. Raise the projector with the mounting bracket
attached and slip though the hinge pin slots
openings on the bracket into the base box.
3. Install the two (2) angle locking screws adjust
the angle, lock it, and then tighten the hinge
pin screws.
Figure 7
1. Check all the hardware for proper tightness and
security. Do not over tighten hardware.
1. Install the two (2) conical spacers and two (2)
flat washers, two (2) hinge pin screws loosely
on both sides of the base box.
2. Raise the projector with the mounting bracket
attached and slip though the hinge pin slots
openings on the bracket into the base box.
3. Install the two (2) angle locking screws adjust
the angle, lock it, and then tighten the hinge
pin screws.
Figure 8