Filter
Top Products
37
e Insert the lamp unit until it is fully in
f Tighten the screws of the lamp unit and
close the handle
● Fasten the 2 screws with a F screwdriver.
g Attach the lamp cover and fasten the
screw
● Fasten the 1 screw with a F screwdriver.
h Attach the control panel cover
Handling the Lamp Unit
Do not touch the glass surface of the lamp directly
with your hand or stain it. Touching it with a bare
hand may dirty the surface, hence shortening the
lamp life, causing marked performance deterioration
such as darkened screens, lamp blowout as well as
malfunction.
NOTE:
When fitting the lamp cover, insert the left end (with 2
claws) of the lamp cover into the unit, followed by
ensuring that the protruding part on the reverse side
of the lamp cover fits snugly into the hole of the unit.
As this protrusion acts as a switch, misfitting may
lead to failure in turning on the power.
Lamp Cover
Handling the Control Panel Cover
● The gap between this unit and the control panel
cover is narrow. Be careful not to stick your finger
into the gap between this unit and the control panel
cover.
● Be careful of the protrusions and corners of
components to avoid injury.
● After attaching the control panel cover, check that
the lock is fastened. The control panel cover may
drop and cause injury.
Control Panel Cover
Fasten the lock
on the control
panel cover
ENGLISH
DLA-HD10_EN-FR.book Page 37 Thursday, November 10, 2005 12:54 PM