Filter
Top Products
Positioning Pin
Lens Cap
Lens Sheet
Front Cover
Top Panel
Positioning Pin
CN80Z0CN80F0
Clamp
Zoom Motor Cable
Motor
Lens Cap
Shift Lock Screw
Shift Lock Screw
Mounting the Lens
When a zoom lens is used
When a short focal length lens is used
● When removing the lens cap, pull out without turning it.
● Do not scratch or knock the lens surface.
● Connect the zoom motor cable (3 pin) to “CN80Z0”, and the focus motor cable (2 pin) to “CN80F0”.
● Connect the focus motor cable (2 pin) to “CN80F0”.
● Insert the lens with the motor facing upward.
● Align the positioning pin of the projector (1 each on left and right sides) with the positioning pin
of the lens.
2 Remove the lens sheet attached to the lens mount at the front cover
3 Remove the lens cap of the end to be inserted into the projector
4 Insert lens into the mounting hole
5 Tighten the 5 screws using the hexagonal wrench with a diagonal size of 3 mm (Bondhus
type recommended) to fasten the lens
7 Clamp the motor cable
6 Connect the motor cable
● Retain these shift lock screws for future use during transportation.
8 Unscrew the 2 shift lock screw
NOTE:
● Remove the top panel if possible to
ease the mounting process. For details on
how to remove the top panel, please consult
your authorized dealer or refer to the service
manual.
● Remove the lens cap before projection.
9 Attach the front cover, and fasten using the 6 screws using a Phillips screwdriver
CAUTION:
Before attaching the lens, check to make sure that the power of the projector is not turned on and the
power cord is not connected. Failure to do so may cause electric shock or injuries.
1 Unscrew the 6 screws using a Phillips screwdriver to remove the front cover
5
4
1
2
6
7
Focus Motor
Cable
CAUTION:
● Keep the cable away from the motor gear
when clamping the motor cable.
C
M
Y
CM
MY
CY
CMY
K
SH4KNL_EN_Lens_sheet-2.pdf 2008/06/04 21:08:06