Filter
Top Products
2
INSTALLATION
● The same installation procedure applies to all Input Cards.
● If the Input Card is installed correctly, your Monitor will automatically recognise it.
● Refer to the user manual provided with your Multi-Format Monitor or Color Video Monitor
for details on adjustment or setting of input signals via the Input Card.
ⅥPREPARATION
When using the IF-C21SDG, IF-C51SDG, IF-C21HSDG, or IF-C51HSDG:
Depending upon the monitor in which the card is inserted, it may be necessary to set the DIP switches
on the Input Card. See page 7 “DIP SWITCHES” for details.
• Wear gloves to protect your hands from metal parts on the Input Card’s board.
• You will need a 6 mm Phillips screwdriver.
• Turn off the Monitor’s main power and unplug the power cable from the AC outlet.
ⅥCAUTIONS
• Do not touch the terminal connected to the monitor or board pattern. (Doing so may produce static
electricity that will damage the Input Card.)
• Do not remove slot covers from the monitor’s slots if they are not in use.
• Do not force the Input Card into the monitor’s slot.
ⅥINSTALLATION PROCEDURE
1.
Unscrew the screws and remove
the slot cover from the slot (on the
rear side of the monitor) in which
the card is to be installed.
2.
Insert the Input Card board (green)
into the slot, fitting the board into
the guide rails at the top and
bottom of the slot.
3.
Push the Input Card in so that its
front panel touches the rear panel
of the monitor. (Insert the Input
Card while holding the knobs at
top and bottom).
4.
Secure the Input Card by replacing
the screws removed in Step 1 above.
● Make sure the Input Card is correctly
installed by checking “SLOT CONDITION”
on the Main Menu of the Multi-format
Monitor. (Also refer to the Multi-format
Monitor instruction manual.)
● Press the INPUT SELECT button on the
color video monitor to make sure that the
Input Card is correctly installed. (Also refer to
the Color Video Monitor instruction manual.)
SLOT1SLOT3
SLOT2
MAKE/TRIGGER
REMOTE
RS-485
IN
OUT
SLOT1SLOT3
SLOT2
MAKE/TRIGGER
REMOTE
RS-485
IN
OUT
SLOT1SLOT3
SLOT2
MAKE/TRIGGER
REMOTE
RS-485
IN
OUT
Slot cover
Rear side of multi-format
monitor
Fit board to
guide rails
Knob
Input Card
(illustration shows
the IF-C12HSDG)
Guide rails
Knob
01_EN 03/4/21, 21:242