Filter
Top Products
2
7 Preparation
• Wear gloves to protect your hands from metal parts on the unit.
• You will need a 6 mm Phillips screwdriver.
• Turn off the Monitor’s main power and unplug the power cable from the AC outlet.
7 Cautions
• Do not touch the wires or board pattern inside of the unit to keep them from being damaged.
• Do not put any object into the unit from the holes on the unit.
• Do not force to tighten the screws when attaching the unit to the monitor.
• Keep the connector cover attached to the monitor’s connector if the unit is not attached to the monitor.
• Do not touch the connector on the right side of the unit. This connector is used only for servicing.
1.
Attach the wire connector to the
connector on the input unit.
Attach the wire connector fully to the
input unit’s connector.
2.
Take out the screws and remove the
connector cover from the monitor.
• Do not take out other screws than the
ones used for the connector cover.
• Keep the connector cover and the
screws after removing.
3.
Attach the input unit to the monitor as illustrated.
Installation
Secure the input unit using
the supplied screws (x 2).
EN_LCT1878-001A.p65 05.5.2, 7:43 PM2