Filter
Top Products
15
Configuring your remote control
You can configure your monitor’s remote control to operate your
other devices.
Configure your remote control.
z If none of the code works, refer to “Using the search code
function” (P. 16).
1 Turn on the device manually.
2 Switch the remote control mode to a mode that
matches your device. Refer to the table below to
select an appropriate mode.
z The indicator lights for 3 seconds each time the remote
control is operated.
3 Find the remote control code for your JVC device
from the table below.
MODE Applicable devices Remote control codes
TV This monitor only
STB Not in use
DVD
DVD 0503, 0539, 0623, 1241, 1550,
1602, 1701, 1860, 1863, 1940
DVD/DVD-R 1164, 1275, 1597
Home Theater in Box 0623, 1701, 1860, 1863, 1940
AUDIO
Receiver/Home
Theater in Box
0074,1374,1676, 2000, 2001
TV STB
AUDIO
DVD
4 Set the remote control code.
5 Point the remote control at your device, press
and confirm that your device is turned off. If your
device does not respond, try entering another
available code.
Press and hold Enter four digit
number
Release the button
Note
LCD
GD-463D10U_EN.book Page 15 Monday, June 8, 2009 4:20 PM