Filter
Top Products
E
ENGLISH
2.
Connect the two LVD power cables (6P) to the SE-LVD
conversion board.
Ⅵ Both cables have identical connector types, so that ei-
ther cable can be connected to either connector on the
SE-LVD conversion board.
3.
Connect the internal SCSI (SE) cable (50P) to the SE-LVD
conversion board.
Ⅵ The other end of the internal SCSI (SE) cable is con-
nected to the library SCSI board in the library.
4.
Connect the internal SCSI (LVD) cable (68P) to the drives.
Ⅵ The other end of the internal SCSI (LVD) cable is con-
nected to the SE-LVD conversion board.
Connecting the cables
Library
<SE-LVD conversion board>
To each drive
Internal SCSI (LVD) cable
LVD
power cable
Internal SCSI (SE) cable
3.
4.
5.
6p
6p
50p
68p
Drive 4
Drive 3
Library SCSI board
Internal SCSI
(SE) cable
To SE-LVD conversion board
Drive 2
Drive 1
Terminator
Internal SCSI cable (approx. 1.0 m)
Terminator
<Interior of library>
<With the MC-8100LU>
1.
Secure the cover with the screws that were removed.
"Procedure for Opening the Drive Storage Cover of
the CD/DVD Library" on page 3.
1.
Close the door and lock the key cylinder.
Procedure for Attaching the Drive
Storage Cover of the CD/DVD Library
Procedure for Closing the CD/DVD
Library Door
<MC-R434U DIP switch settings on the rear panel>
Procedure for Setting the DIP Switch
●
Set the SCSI ID of the MC-R434U and close the door
of the CD/DVD Library.
Always turn the power of the CD/DVD Library off when
the dip switches are moved.
For the details of the default factory settings, please
refer to the section "SCSI ID No. SETTING" of the
instructions from the CD/DVD Library.
SETUP
<SCSI ID No. and DIP switch settings>
*
: Factory setting.
SCSI ID No.
Switch
ID2 ID1 ID0
0 OFF OFF OFF
1
*
OFF OFF ON
2 OFF ON OFF
3 OFF ON ON
4ONOFF OFF
5ONOFF ON
6ONONOFF
7ONONON
ON
OFF
(Factory setting)
RSV
ID 2
ID 1
ID 0
ON
1234
1.
ID2, ID1, ID0: Setting of the SCSI ID No. of each drive.
Ⅵ When setting the SCSI ID No., use a number that is not
being used by other SCSI devices on the same bus.
Ⅵ The MC-R434 should be used with one of the SCSI ID
No. 0 to 7. It cannot be used with No. 8 to 15.
Ⅵ RSV: Not available
03.11.17, 5:15 PM5