Filter
Top Products
(No.XE003)1-7
3.1.7 Removing the top case(See Figure 12 and Figure 13)
• Prior to the following procedure, the LCD panel assembly
should be removed.
(1) Remove four screws H and two screws I from the shield
plate.
H:long I:short
(2) Remove two screws J that are attached to the top case as-
sembly.
J : black
(3) Disconnect wires from each connector CON3
,CON4, and
CON10 on the main board.
Fig.12
(4) Remove four screws K and one screw L from the bottom of
the main unit.
K : long L : short
(5) Release seven tabs h on the top case.
Fig.13
3.1.8 Removing the main board(See figure 14)
• Prior to the following procedure, LCD panel assembly and top
case assembly should be removed.
(1) Remove four screws M and one screw N from the main
board.
M : silver N : black
Fig.14
Tab h
H
CON3CON4
I
I
Shield plate JJ
H Top case
Tab hTab h
CON10
K K
L
K
K
MMM
N
M
Main board