Filter
Top Products
6) Removing the lamp assembly.
Using the hex wrench included with the replacement lamp, loosen
the two hex screws fastening the lamp assembly unit. Remove the
screws and set aside. When the screws have been removed, remove
the lamp assembly by grabbing the handle and sliding the assembly
towards you.
7) Install the new lamp unit
Slide the new lamp assembly into the television by holding the han-
dle attached to the unit. When the new lamp assembly is securely
installed inside the television,
replace the hex screws using
the hex wrench. To ensure
the new lamp assembly sits
properly inside the television,
secure the right hex screw
first, then the left. If the lamp
assembly does not sit
securely inside the television,
the television will not turn on.
WARNING!
Remember, it is very important you DO NOT TOUCH THE GLASS
SURFACE OF THE NEW LAMP. Please re-read the warnings on
page 2 regarding the new lamp unit.
This lamp is only for use with the AV-61S902. It is designed to work
specifically with the AV-61S902. Using this lamp with a different
television or other product could cause a malfunction and/or damage to
the television or the lamp.
THE USED LAMP MUST BE RECYCLED IN THE US. See the includ-
ed sheet and page 63 of the AV-61S902’s User’s Guide for detailed
recycling information for customers in the US.
Handle
Light-source lamp unit
Hex wrench
The lamp assembly in this product contains mercury. Disposal of the lamp
assembly may be regulated due to environmental considerations. For
information on replacement, disposal or recycling procedures, please
contact JVC Customer Relations at 1-800-252-5722.
6