Filter
Top Products
12 EN
SECTION FOR Macintosh (cont.)
Copying Image Data from the Digital
Video Camera to the Computer
For details on the basic operation of Mac, refer to
the instruction manual provided with your Mac.
Preparation
Start Macintosh.
● Insert the memory card into the camera. Make
sure in advance that the memory card contains
data which you want to copy onto the Mac.
1
Set the VIDEO/DSC switch to “DSC”.
2
Turn the camera’s POWER switch to “ ”.
3
Connect the camera to the computer using
the provided USB cable. (੬ pg. 10)
•“USB MODE” appears on the LCD panel.
4
Confirm the “untitled” icon appears on the
desktop.
•If the camera is connected to the computer
properly, the “untitled” icon appears.
5
Double click the “untitled” icon and copy the
desired files from the still image data folder.
NOTES:
●
After the data has been copied, drop the
“untitled” icon in the trash and disconnect the
USB cable.
●
Always initialize a Memory Card (a
MultiMediaCard or an SD Memory Card) before
using it with the digital video camera. (For details
on the initialization procedure, refer to the digital
video camera’s manual.)
If the camera is connected to a personal computer
through the USB interface, there are circum-
stances in which it might not be possible to read
or write files.
●
When a file is being accessed from a personal
computer, the message “ACCESSING FILE” is
displayed on the LCD panel on the camera. Never
disconnect the USB cable while this message is
displayed.
●
Disconnect the USB cable and then turn the
computer off or operate the Power dial on the
camera.