Filter
Top Products
8
Using Your Snugasabug
®
Fitted
Electric Blanket continued
To Detach The Controller
The socket has a locking clip that
engages with a small pin on the plug.
Ensure the electric blanket controller is
in the ‘OFF’ position and not connected
to the 230V or 240V power supply.
With the controller set to the ‘OFF’
position, push the clip out to release
the socket pin and withdraw the
connector plug by pulling it away
from the socket.
Storing Your Control Unit
Remove the controller when
laundering your blanket. Store your
controller during summer months
while your blanket remains on the bed
as a comfortable underblanket.
Dual Control Units
Your Double/Queen size electric
blanket features two controls for
individual comfort.
Turning Your Fitted Electric
Blanket On
Ensure the electric blanket controller is
positioned in the ‘OFF’ position. Move
the switch on the controller in an
upward direction and the word ‘OFF’
will be displayed.
Plug the cord into a 230V or 240V
power outlet and switch the power
on.
Pass the controller and cord through
the apertures in the skirt section of the
blanket.
Ensure that when the blanket is fitted
onto the mattress the controller/s and
flexible power supply are outside of
the bed and coverings and located in
a position that will prevent accidental
damage to the housing and cords
Use this blanket only as an under
blanket and do not use above the
occupant of the bed.
Fixing The Removable Cover
(Only KEB513 and KEB533
models)
When fixing the removable cover in
position, ensure the fleecy side of the
cover is on the uppermost side. Secure
the removable cover using the studs
fastened over the complete cover.
There should be no rucking of the
removable cover when the studs are
completely fastened.
No other cover other than that
supplied with the blanket should be
used with the electric blanket.
To Connect The Controller
Your blanket has a detachable
controller and waterproof element
which makes it machine washable.
Ensure the electric blanket controller
is in the ‘OFF’ position and not
connected to the 230V or 240V power
supply.
To connect your controller, thread the
detachable plug from the controller
through the slot in the mesh skirt and
plug it fully into the socket.
Ensure that the locking clip engages
with the small plastic pin on the plug.
KEB413_IB_FA.indd 8 12/10/09 10:03 AM