Filter
Top Products
Application:
Ken-A-Vision's Aqua Flex is a CCD camera with built in "cool light"
source for use underwater. Camera is ideal for use in classroom aquaria
(fresh or saltwater), and/or in relatively non-turbid aquatic situations (lakes,
ponds, streams, tidal pools) where visualization of organisms or structures is
desired. Camera will send a clear picture back to a TV monitor, LCD
projector or VCR directly. If a USB adapter (Ken-A-Vision USBAD2) is
connected to the camera, individual, time lapse, time lapse movies or video
movies can be captured and stored on a computer, Applied Vision
®
Software for Windows
®
is supplied with the adapter, and also allows Video
Streaming and FTP uploading.
Specifications:
Water Proof 50 ft. (15.2 m)
Video Cable 33 ft. (10 m)
Connection Video RCA Jack
Mounting Thread 1/4 20
Horizontal Attachment
Brackets 2
Leader 1 - suspends unit in horizontal
position for hooking on
to pole or bar.
Illumination Ken-A-Vision "Cool light"
Weight 2 lbs. (0.91 kg.)
Image Output Composite (NTSC or PAL)
Focal Distance 3.9 in. or 10 cm. to infinite: fixed
Magnification 50:1 or greater
Power Supply 250mA @ 5 volts DC
(KAV Part Number AFPS)
Warranty 1 year
Optional Accessories:
Submergible Extension Rod
Car Adapter (for power)
Outdoor Nature Trail Pack
Aqua Flex Preparation:
Note: Be careful not to submerge 110v end of power cord.
Powering up Aqua Flex camera -
1. Plug the Power Supply into the red end plug of the
Video Cable.
2. Plug the Yellow video plug into the TV
monitor, LCD Projector or VCR. (note-VCR cord can be
extended by a video cable extension available in many electronic
stores)
3. Plug power Supply cord into electricity source.
4. Picture should appear on monitor.
Preparation of Aqua Flex Camera -
1. Camera is ready to submerge in water as shipped.
It can be placed on bottom or suspended.
NOTE: It is not recommended that camera be
suspended or maneuvered by the Video Cable
itself, as continued pulling on cord will shorten the
life of the camera and it's electrical hookup.
2. Camera can be suspended or maneuvered by
screwing a 1/4 20 screw mount into the base of the
camera, in the hole provided. (This is a standard
camera tripod mount, or a piece of 1/4 20 all-screw
can be purchased at a hardware store, or a 1/4 20
bolt can be mounted on the end of a rod and then
connected to the camera).
3. If camera to be suspended horizontally in water,
either hook suspension apparatus directly to two
mounting hooks provided, or hook leader to the two
mounting hooks, and connect leader to suspension
apparatus.