Filter
Top Products
English 79
Connecting Wires to Terminals
Connect to vehicle's reverse lamp
harness when using the optional rear
view camera.
(Parking sensor wire)
Connect to the vehicle's parking
brake detection switch harness.
For best safety, be sure to
connect the parking sensor.
⁄
Light Green
Extension cable (Accessory 2)
Antenna Cord
FM/AM antenna input
Accessory 1
FUSE ( 10A )
If no connections are made, do not let the cable come out from the tab.
(Mute control wire)
Brown
To the terminal that is grounded when either the telephone
rings or during conversation. (To connect the Kenwood
navigation system, consult your navigation manual.)
To car light control switch
(Dimmer control wire)
Orange/White
Depending on what antenna you are using, connect either
to the control terminal of the motor antenna, or to the
power terminal for the booster amplifier of the film-type
antenna. (Max. 300 mA, 12 V)
(Antenna control wire)
Blue
When using the optional power amplifier or optional
smartphone adapter (KCA-ML100), connect to its power
control terminal. (
☞ page 81)
(Power control wire)
Blue/White
Yellow (Battery wire)
Red (Ignition wire)
White ª / White/black · : To front speaker (left)
Gray ª / Gray/black · : To front speaker (right)
Green ª / Green/black · : To rear speaker (left)
Purple ª / Purple/black · : To rear speaker (right)
(Reverse sensor wire)
Purple/White
Bluetooth Microphone
(Accessory 6) DDX6033BT/
DDX6033BTM/DDX4033BT/
DDX4033BTM only
Ignition key switch
ACC
Car fuse box
(Main fuse)
Subwoofer Preout (monaural)
Black (Ground wire) · (To car chassis)
Battery
Not used
Connect to vehicle's
steering remote harness.
Contact your Kenwood
dealer for details.
Extension cable (Accessory 7)
EN_GET0908-001A_MX.indb 79EN_GET0908-001A_MX.indb 79 12/11/13 11:4612/11/13 11:46