Kenwood KVT-556DVD Computer Drive User Manual


 
90 KVT-526DVD/KVT-556DVD
Some functions of this unit may be disabled by
some settings made on this unit.
! • Cannot set up the subwoofer.
• Cannot set up subwoofer phase.
• No output from the subwoofer.
• Cannot set up the low pass filter.
• Cannot set up the high pass filter.
Subwoofer is not set to On.
<Audio Setup> (page 58)
Preout is set to "Rear".
<System Setup> (page 62)
The Dual zone function is enabled.
<Zone Control> (page 82)
! Cannot set up the subwoofer phase.
Subwoofer is not set to On.
<Audio Setup> (page 58)
Low pass filter is set to Through.
<Crossover Network Setup> (page 59)
! • Cannot select the output destination of the
subsource in the Dual zone.
• Cannot adjust the volume of the rear
speakers.
The Dual zone function is disabled.
<Zone Control> (page 82)
! Cannot play audio files.
"CD Read" of <System Setup> (page 62) is set
to "2".
! Cannot Folder select.
The Scan play or Random play function is
enabled.
! Cannot perform Repeat play.
The PBC function is enabled.
! • Cannot set up the equalizer.
• Cannot set up the crossover network.
The Dual zone function is enabled.
<Zone Control> (page 82)
! Cannot watch the source selected as AV-OUT
in the rear monitor.
A source control screen is displayed in front.
<AV lnterface Setup> (page 64)
"AV-OUT Graphic Output" of <AV Interface
Setup> is set to "Black".
What might seem to be a malfunction in your unit
may just be the result of slight misoperation or
miswiring. Before calling service, first check the
following table for possible problems.
General
? The Touch Sensor Tone doesn’t sound.
The preout jack is being used.
The Touch Sensor Tone can’t be output from
the preout jack.
Tuner source
? Radio reception is poor.
The car antenna is not extended.
Pull the antenna out all the way.
The antenna control wire is not connected.
Connect the wire correctly, referring to the
section on <INSTALLATION MANUAL>.
Disc source
? The specified disc does not play, but another
one plays instead.
The specified disc is quite dirty.
Clean the disc.
The disc is severely scratched.
Try another disc instead.
Audio file source
? The sound skips when an Audio file is being
played.
The media is scratched or dirty.
Clean the media, referring to the CD
cleaning of the section on <Handling discs>
(page 4).
The recording condition is bad.
Record the media again or use another
media.
Help? Troubleshooting