Filter
Top Products
7
1
CONNECTING TO A TNC (E MARKET MODELS ONLY)
To connect an external TNC to the transceiver, use an
optional PG-5A cable. The DATA connector on the rear
of the transceiver mates with the 6-pin mini-DIN plug on
this cable.
.oNniP emaNniP noitcnuF
1DKP
tupniatadtekcaP
•reviecsnartotCNTmorfatadXT
2DNGDKProfdnuorG
3SKP
ybdnatstekcaP
•ehttibihniotnipsihtesunacCNT
tupnienohporcimreviecsnart
.slangistekcapgnittimsnartelihw
49RP
spb0069detcetedfotuptuO
Vm005(atad
P-P
k01, )
•nipnommocasasnoitcnufoslA
atadspb0069dnaspb0021rof
.tuptuo
51RP
spb0021detcetedfotuptuO
Vm005(atad
P-P
k01, )
6CQS
tuptuolortnochcleuqS
•gnittimsnartatadCNTstibihnI
.neposihcleuqsreviecsnartelihw
•eciovotecnerefretnistneverP
emasehtnosnoitacinummoc
.seirterstneverposlA.ycneuqerf
•leveLtuptuO
)hgiH(V5+:hcleuqsnepO
)woL(V0:hcleuqsdesolC
Note:
◆ If the external TNC has a common pin for 1200 bps and 9600 bps
data output, connect this pin to the DATA connector PR9 pin.
Shorting the PR9 and PR1 pins will cause the TNC to malfunction.
◆ Adjust the transceiver data communication speed (1200 bps or
9600 bps) as necessary {page 58}.
◆ If DC voltage is input to the PR1 pin, the external TNC may not
function. If this problem happens, add a 10 µF capacitor between
the PR1 pin and the TNC. Be careful with the polarity of the
capacitor.
GND