Kingston Technology KNS1600R Switch User Manual


 
8 Rear Panel
Kingston Technology Company KNS1600/R User’s Guide - Rev. B00
Rear Panel
Figure 2 – KNS800/R Rear Panel
Power Switch
The AC Power switch turns the unit kj or kbb. If the PWR LED does not
light up when the unit is turned on, please check the following:
1.
Try a different AC power outlet.
2.
Check the external fuse located in the back of the unit (below the AC
power connector.) If the fuse is blown, replace it with the spare fuse
provided with the unit (located below the AC power connector).
3.
The power supply may be defective. Return the unit for replacement.
)
WARNING: For safety reasons, DO NOT attempt to open and
service the unit. There are no user-serviceable components inside.
AC Power Connector
The Fast EtheRx switch uses an auto-sensing 100VAC-240VAC, 50/60Hz internal power
supply. Connect the AC power cord from the back of the unit to an AC electrical outlet.
Fuse
The Fast EtheRx switch comes equipped
with a 250V (2 Amp max.) external fuse
and one spare fuse. Both fuses are located
in a fuse holder located just below the AC
power connector on the back of the unit.
Spare
Fuse
Fuse (250V, 2A)
USE ONLY WITH A 250V FUSE
U
S
E
O
N
LY
W
IT
H
A
2
5
0V
F
U
S
E
Fan Units
The Fast EtheRx Switch uses two independent cooling fans for optimum air- flow to
safeguard the unit from unnecessary heat exposure.
USE ONLY WITH A 250V FUSE
Fan UnitFan Unit
Fuse (250V, 2A)
Power Switch
AC Power
Connector
MDI / MDI-X
Configuration Table