Filter
Top Products
6
Calibrate Printer
b) Remove the calibration sheet from the output tray.
Place it face down and align to the front, right corner
of the scanner glass, as shown.
IMPORTANT: The blue arrow in the corner of the
calibration sheet must point to the registration
marks as shown.
IMPORTANT: Make sure that the photo tray is
pushed in. The photo tray light should be lit.
a) Press Start. Wait two minutes for the calibration sheet
to print.
Tip: If the calibration sheet does not print properly,
see the Troubleshooting section in this setup guide.
4x6
www.kodak.com/go/aiosupport
c) Lower the scanner lid and press Start. Remove the
sheet from the scanner glass when the calibration
is complete.
d) Lift the photo tray lid, then slide the photo tray toward
you to return to main tray operation. The photo tray
light will turn o.
10
4x6
4x6