Filter
Top Products
Cleaning the pick roller tires
Rotate the roller release lever up.
Push the pick roller to the right and remove it.
Scrub the roller tires in a side-to-side motion with a
roller cleaning pad and re-install the roller. Re-
install the pick roller when finished
.
Cleaning the drive roller tires
Remove the drive roller by pushing the roller to the
right. Hold the drive roller in place and slide it off
the shaft. Gently release the drive roller shaft back
into position.
Cleaning the separation roller
Pull the separation roller door forward and remove
the separation roller. Scrub the tires in a side-to-
side motion with a roller cleaning pad and re-install
the separation roller.
Cleaning the sensors
Use the blower brush to clean all 7 sensors. The
feed sensor is shown above.
Clean the gap sensors, page entry sensors and
pass thru sensor.
Clean the exit sensor which is located on the
transport toward the back of the scanner
.
For replacement procedures and detailed cleaning procedures see Chapter 6, Maintenance in the User’s Guide.