Kodak A Projector User Manual


 
Replacements and Installations
SM4530-1 – 30APR96 5
Replacing the FAN SHAFT ASSEMBLY
Warning
Dangerous Voltage
[1] Disconnect the main power.
[2] Do the replacement procedure for the LOWER HOUSING ASSEMBLY.
[3] Cut the 3 WIRE TIES:
1 on BLOWER COVER wires
2 on SMALL CIRCUIT BOARD between the MOTOR and MECHANISM ASSEMBLY
[4] Disconnect the 2 wires from the CYCLE SOLENOID on the SMALL CIRCUIT BOARD.
[5] Pull the SMALL CIRCUIT BOARD up.
[6] Remove the
Torx SCREW from the BLOWER COVER ASSEMBLY.
[7] Lift the GRILLE ASSEMBLY in front of the BLOWER COVER ASSEMBLY up.
[8] Loosen the
Torx
SCREW on the right track of the LOWER LIGHT BAFFLE ASSEMBLY appoximately half way.
[9] Lift the LOWER LIGHT BAFFLE ASSEMBLY off the TAB on the BLOWER COVER ASSEMBLY.
[10] Remove the 2 long
Torx
SCREWS from the BLOWER COVER ASSEMBLY.
A100_0013HA
BR and KK models
A100_0013HCA
WIRE TIE (not shown)
BLOWER COVER WIRE TIE
GRILLE ASSEMBLY