Filter
Top Products
26 A-61557 December 2006
6. Lift and remove the back cover.
NOTE: If the back cover does not easily lift up, be sure that the exit
stop wire is pulled out approximately 4 inches.
7. Loosen and remove the thumbscrew that holds the scan tower door
in place.
8. Open the scan tower door.
9. Using the cleaning swab wipe both surfaces of the scan heads.
10.Close the scan tower door and reinstall the thumbscrew.
11. Replace the back cover first, then the side cover and turn the
scanner on.
NOTE: Be sure the yellow wires are clear of the back cover when you
reinstall it.