Filter
Top Products
20 A-61579 February 2007
- Viewing the Operator Log
This log is reset whenever the scanner is powered off but the messages are still
available through the internal scanner log visible though SVT (Scan Validation
Tool)
Log messages with a time stamp of 12:00:00 are normal when first powering on
the scanner. These messages happened before the scanner was able to connect
to the host computer and determine the local time.
- Information
Last image Address / Total documents Scanned / Firmware version
- Count Only mode
This function can be used if you just want to count the pages in a batch but not
scan them. This can also be used to run the transport cleaner sheets during
maintenance.
- Print Test
Prints ladder test pattern (see BASIC PRINT section for more information)
- Patch Test
This function can be used to test the quality of your patch sheets. If your patch
sheets are not being read by the scanner, run this test to find any poor quality
patch sheets.
¾SETTINGS
- Volume: used to change the volume of the scanner speaker.
- Tones: used to change the alert tones used for functions, such as, multifeed alert.
This is useful if more than one scanner is in the same area.
- Language: the language that is used for the buttons on the OCP can be changed
with this function. The operator can easily select whichever language they are most
comfortable with without rebooting the scanner.
Each student should navigate through the menus on the touchscreen and perform the
following:
- View the Message Log screen.
- View the Scanner Information screen.
- Scan a stack of documents in Count Only mode.
- If using printing, put some plain white paper in the feeder and run a print test.
- If using patch sheets, put some patch sheets in the feeder and run a patch test.
- Set the Volume, Tones and Language to their personal preferences.