Filter
Top Products
SERVICE MANUAL
20 30APR96 – SM4530-1
Caution
The TABS could break.
[3] Bend the 3 TABS of the LAMP BRACKET ASSEMBLY.
[4] Lift the top of the LAMP BRACKET ASSEMBLY up.
[5] Rotate and push the LAMP TERMINAL ASSEMBLY until it releases.
[6] Remove the LAMP TERMINAL ASSEMBLY.
Installing the LAMP SOCKET TERMINAL ASSEMBLY, Painted Models
[1] Do the replacement procedure for the LAMP SOCKET TERMINAL ASSEMBLY in reverse order and check the
following during installation:
• Check that the LAMP EJECTOR is aligned correctly before you install the LAMP TERMINAL ASSEMBLY.
• Check that the LAMP TERMINAL ASSEMBLY wires are aligned correctly.
• Bend the 3 TABS down until they are flush with the top of the LAMP BRACKET ASSEMBLY. If the TABS
break, use TOP PLATE SCREW 785130 to install a new TAB.
Replacing the LENS MOUNT ASSEMBLY - Auto Focus Model
Warning
Dangerous Voltage
[1] Disconnect the main power.
[2] Do the replacement procedure for the LOWER
HOUSING ASSEMBLY.
[3] Remove the FOCUS KNOB.
[4] Remove the short, gray wire connected to the
AUTO-FOCUS DEFEAT SWITCH.
Important
It is necessary to push the AUTO-FOCUS BRACKET
backward and forward to allow access to the SCREWS
on the LENS MOUNT ASSEMBLY.
[5] Remove the 3 SCREWS from the LENS MOUNT
ASSEMBLY.
[6] Lift and remove the LENS MOUNT ASSEMBLY.
Installing the LENS MOUNT ASSEMBLY - Auto Focus Models
[1] Do the replacement procedure for the LENS MOUNT ASSEMBLY in reverse order.
A100_0019GA
SCREW (3)
ASSEMBLY
LENS MOUNT
A100_0019GCA