Filter
Top Products
5 KODAK Premium Rapid-Dry Photographic Papers / 260g
٠
E2635
FINISHING
Detailed information and tips can be found in KODAK
publication E-2600, Laminating, Mounting, and Finishing
KODAK Wide-Format Inkjet Media.
Lamination
Please refer to lamination chart in compatibility
sections above for specific printer/ink/laminate
recommendations.
Lamination Definitions
Heat Activated
Thermal, 210-240°F
(99-116°C)
*
Polyester laminates applied with hot roll
laminators at 210-240°F.
Heat Activated Low
Temperature, 185-
195°F (85-91°C)
*
Polyester laminates applied with hot roll
laminators at 185-195°F.
Heat Assisted, 185-
195°F (85-91°C)
Polyester or vinyl laminates with pressure
sensitive adhesives; specially formulated
for inkjet prints, and applied with hot roll
laminators at 185-195°F.
Pressure Sensitive,
Ambient to 120°F
(49°C)
Polyester or vinyl laminates with pressure
sensitive adhesives on a release liner,
applied at ambient conditions or at low
temperature, 100-120°F.
*
For both Heat Activated Thermal and Low Temperature, use a laminate
with a total thickness (polyester and adhesive) of 3 mils or less on the face
side. Thicker laminates may be applied to the back of the print for
increased total thickness.
Prints must be laminated prior to display to ensure
optimum performance and guard against dye fade due
to environmental pollutants.
Successful lamination requires that inkjet media be
completely dry to ensure good adhesion and to avoid
unwanted color shifts. While prints may feel dry to the
touch, components of the ink that prevent good
adhesion or may cause the color to change may still be
present. The best drying is achieved while prints are
exposed to air, not stacked or on a roll. For best results,
use inkjet-specific laminate products.
For increased durability, choose a laminate with UV
protection and encapsulate with a 1/4-1/2” (6.5-13 mm)
seal around the edges of a print to prevent moisture and
other airborne pollutants from reaching the image.
Heavier weight papers may require a wider edge seal.
Mounting
Prints can be mounted, laminated or not, to a variety of
materials, including poster board, foam board, SINTRA,
LEXAN and more. Use inkjet-specific adhesive materials
and follow the manufacturer’s instructions.
DISPLAY
KODAK inkjet media is intended for display in typical
home, office, and retail environments. Unusual
conditions, such as extreme temperatures or humidity,
may affect the expected lifetime of the displayed print.
KODAK is unable to test all possible environments, so it
is recommended to test display conditions when
possible to be sure that the media meets the necessary
requirements