Filter
Top Products
Radio operation
1. Slide the switch ALARM ON/OFF/AUTO
e
into the position "ON".
2. To switch on, turn the volume controller OFF/BUZZ/VOLUME
o
until
an audible »Click« is heard.
3. Using the volume controller OFF/BUZZ/VOLUME
o
now set the desired
sound volume level.
4. Place the waveband selector switch
t
at the desired frequency range
(FM/AM).
5. Adjust the tuning regulator
d
to select the desired radio station. The
frequencies can be read off from the frequency scale
s
.
6. To switch off, slide the switch ALARM ON/OFF/AUTO
e
into the position
"OFF".
Note:
The radio is only switched off when the switch ALARM ON/OFF/AUTO
e
is
at the positions OFF or AUTO. To simply turn the sound volume regulator
o
to very quiet, until a »Click« is heard, is not sufficient.
Setting up the telescope aerial
• Remove the telescope aerial
w
from its retainer and set it up.
• Extend the telescope aerial
w
completely.
To improve reception in the FM frequency range, slowly turn the end of the
telescope aerial
w
in various directions. As soon as you have found a position
with good reception from your desired radio station, leave the telescope
aerial
w
in this position. For the reception of AM transmissions, an antenna
is built into the device. For improved reception, alter the position of the device
in radio mode.
- 9 -
IB_KH2198_99_DT42360_LB6.qxd 17.12.2008 11:32 Uhr Seite 9