Filter
Top Products
2
15
2-1-3-1. Management through Ethernet Port
There are two ways to configure and monitor the switch through the switch’s
Ethernet port. They are Web browser and SNMP manager. We just introduce the
first type of management interface. Web-based UI for the switch is an interface in a
highly friendly way.
͒
͒͒
͒C
CC
CManaging 16-Port GbE Web Smart Switch through Ethernet Port
Before start using the switch, the IP address setting of the switch should be
done, then perform the following steps:
1. Set up a physical path between the configured the switch and a PC
by a qualified UTP Cat. 5 cable with RJ-45 connector.
Note: If PC directly connects to the switch, you have to setup the
same subnet mask between them. But, subnet mask may be
different for the PC in the remote site. Please refer to Fig. 2-6 about
the 16-Port GbE Web Smart Switch default IP address information.
2. Run web browser and follow the menu. Please refer to Chapter 4.
16-PORT GBE WEB SMART SWITCH
Default IP Setting:
IP = 192.168.1.1
Subnet Mask = 255.255.255.0
Default Gateway = 192.168.1.254
Assign a reasonable IP address,
For example:
IP = 192.168.1.100
Subnet Mask = 255.255.255.0
Default Gateway = 192.168.1.254
Fi
g
. 2-6
Ethernet LAN