Filter
Top Products
6. Configure from Console
6.1 Hardware Setting for Console
Before using the console connection to configure the switch, please make sure
that you have already install the terminal program "HyperTrm" in your
Windows. If you can not find it in your Windows, please install it first with
your Windows Installation Disk. You can also use other terminal program for
console setting if you already have one.
1. Please connect from the console port of the switch to COM port of PC
(COM1 or COM2) with the attached console cable.
2. Start the terminal program. Select the COM port on PC and set the
operation configuration to [9600,8,N,1] and the terminal interface is Auto.
3. Power on the switch and the following screen will appear on your terminal
screen. If you cannot find it, please restart the terminal program and reboot
the switch.
There are five items in the setup menu. You can select one and follow the
direction to complete the setting.
6.2 Operation in Console
1. System Setting : There is only one item in this function. You can enable or