Filter
Top Products
CHAPTER 5 MANAGEMENT AND SETTING
5-3
Setting
9. Standard size
10. Buzzer
11. Mgr. code
change
Description
Select either “Architecture” or “Engineering” [“A sizes” or “B
sizes”] for the paper size. This will change the media widths
that are automatically detected by the printer.
When the printer runs out of paper or experiences a paper
jam during printing, this status can be conveyed by a buzzer
in addition to the messages displayed on the operation
panel. This feature is particularly convenient when the
printer is not located in the immediate vicinity of the operator.
The buzzer sounds at the following conditions:
• When the printer runs out of paper during printing;
• When the data page size and/or media type differ from
those of the selected paper tray;
• When there is a paper jam;
• When the printer runs out of toner;
• When the waste toner tank is full;
• When the “Call service” message is displayed;
• When another printer error has activated the Attention
indicator on the operation panel.
* To stop the buzzer, press the Stop key or open and close
the front cover.
The password setting for manager can be changed.
* Using the MNOP cursor keys, select a 4-symbol
combination of the up/down/left/right arrows to set the pin
code.
* When changing the pin code, it is recommended that you
make a note of the new code.
Selectable values
Architecture/
Engineering
[A sizes/B sizes]
ON/OFF
– – – – –
Default
Architecture
[A sizes]
ON
qQrR
Page
5-9
5-10
5-10