Filter
Top Products
3. TURNING ALARM OFF (WHILE SOUNDING)
Note:
The alarm will sound for 23 seconds and then increase in volume
and speed for another 62 seconds (85 seconds total). If no button is
pushed it will shut off and be active for the next day.
a. While the alarm is sounding, press the "SNOOZE" bar to disable the
alarm for six minutes.
b. After the "SNOOZE" bar is pressed, the alarm icon will flash in the lower
left area of the display.
c. To disable the alarm for 24 hours, press any button other than "SNOOZE"
or projection keys.
F. CHANGING DISPLAY MODE (DAY, SECONDS, AND ALARM TIME)
There is three possible display modes to view the date, seconds and alarm
time. To change the display (starting at the default of month - date):
1. Press the "MODE/+" button and the display will now show seconds.
2. Press the "MODE/+" button and the display will now show alarm time.
3. Press the "MODE/+" button and the display will now show month - date.
MAINTENANCE & CARE
A. Extreme temperatures, vibrations and shock should be avoided to prevent
damage to the units.
B. Clean displays and units with a soft, damp cloth. Do not use solvents or
scouring agents-they may mark and damage the displays and casings.
C. Do not submerge in water.
D. Immediately remove all low powered batteries to avoid leakage and damage.
E. Replace with new batteries only and of recommended size.
F. Opening the casings invalidates the warranty. Do not try to repair the units.
Contact La Crosse Technology for repairs.
TROUBLESHOOTING
Problem: The Projection is faint
Solution: 1) Change intensity setting
2) Use AC adapter
3) Darken surroundings
4) Use fresh batteries (if AC is not used)
Problem: The LCD is faint.
Solution: 1) Replace the batteries.
Problem: No reception of WWVB signal.
Solution: 1) It may help reception to face the front of the Projection alarm in the
general direction of Ft. Collins, Colorado.
2) Wait overnight for signal.
3) Be sure the Projection alarm is at least 6 feet from any electrical
devices, i.e. TV sets, computers, or other radio controlled clocks.
4) Remove batteries for five minutes, reinsert and leave the unit alone
overnight without pressing buttons.
5) If problems persist contact La Crosse Technology.
Problem: Hour is incorrect (minute and date are correct).
Solution: 1) Be sure correct time zone and daylight saving time are selected.
Note:
For any questions not answered, please contact La Crosse
Technology's Technical Support with the contact information found at
the end of this instructional manual.
SPECIFICATIONS FOR WT-5350
Power source:
AC Adapter (included) Input: 120VAC/60Hz Output: DC 3.4V/100MA
Battery type: Station: 2 x AA, 1.5V (Alkaline) (optional)
Battery life: Approximately 12 months, depending on
projection and light use
Dimensions (L x W x H): 5” x 3.66” x 2.01”
GB
P.22
GB
P.23
GB
P.24
GB
P.25