Filter
Top Products
Page 5 of 8
If the “SNZ” button is pressed, the alarm will silence for
approximately 5 minutes, after which it will begin to
sound again.
The alarm uses 3 different patterns of tone, beginning
gently and increasing in intensity, known as a
"Crescendo Alarm".
Battery Replacement Information
To replace the battery:
1. Lift up the battery compartment cover and remove
the battery.
2. Please take note to install the battery with the
proper polarity as it relates to the battery diagram
inside the battery compartment (+). The battery
will fit tightly. To avoid start-up problems please
ensure that the battery does not spring free.
3. Replace compartment cover.
Help us to keep our environment clean. Please
take any used batteries to an authorized depot
for recycling.
Mounting the Unit
The clock can be set on a table or mounted onto a
wall.
Table Standing
An easel type foldout stand is located on the bottom of
the back side of the clock. Pull the easel out from the
bottom to open it.
Wall Mounting
Select a place to mount the clock. Install a mounting
screw (not included). Align the hanging hole to the
mounting screw and ensure that the clock locks down
into place before releasing it.
Online Resources
Visit the WT-8002 page online at:
http://www.lacrossetechnology.com/8002
Care and Maintenance
Extreme temperatures, vibration and shock should be
avoided as these may cause damage to the unit and
give inaccurate readings.
Precautions shall be taken when handling batteries.
Injuries, burns, or property damage may be resulted if
batteries are in contact with conducting materials,
heat, corrosive materials or explosives. Batteries
should be taken out of the unit before it is stored for a
long period of time.
Page 6 of 8
Immediately remove all low power batteries to avoid
leakage and damage. Replace only with new batteries
of the recommended type.
When cleaning the display and casings, use a soft
damp cloth only. Do not use solvents or scouring
agents as they may mark the LCD and casings.
Do not submerge the unit in water. Furthermore, fix all
parts in place where the units are adequately protected
against moisture and rain.
Special care shall be taken when handling a damaged
LCD display. The liquid crystals can be harmful to
user's health.
Do not make any repair attempts to the unit. Contact
the La Crosse Technology® Warranty Department for
help. Opening and tampering with the unit may
invalidate their guarantee.
Never touch the exposed electronic circuit of the
device as there is a danger of electric shock should it
become exposed.
Do not expose the units to extreme and sudden
temperature changes, as this may lead to reduce their
accuracy.
Troubleshooting
Battery:
Battery problems are the single largest cause of
customer support cases. A few things to check:
Use a fresh battery
Please use a plain Alkaline battery that tests no
less than 1.48 on a voltmeter or with an expiration
date that is 7 years in the future.
Ensure correct polarity
Ensure that the clock has a fresh battery and is
installed using correct polarity as shown inside the
battery compartment (+).
Warranty Information
La Crosse Technology, Ltd provides a 1-year limited warranty
on this product against manufacturing defects in materials
and workmanship.
This limited warranty begins on the original date of purchase,
is valid only on products purchased and used in North
America and only to the original purchaser of this product. To
receive warranty service, the purchaser must contact La
Crosse Technology, Ltd for problem determination and
service procedures. Warranty service can only be performed
by a La Crosse Technology, Ltd authorized service center.
The original dated bill of sale must be presented upon
request as proof of purchase to La Crosse Technology, Ltd or
La Crosse Technology, Ltd’s authorized service center.
La Crosse Technology, Ltd will repair or replace this product,
at our option and at no charge as stipulated herein, with new