3
Installation Tips
Note: These tips are additional to the Installation
Instructions that can be found on the back of
the unit.
▼ All ports on the LMS8-A can support full
duplex operation - please make sure that
each port has the proper switching setting
for the desired modes (default switch set-
tings are for half duplex). When the unit is
powered on, verify the correct modes of
operation by examining the LEDs for each
port. No further configuration is necessary.
If the correct mode of operation does not
appear in the LED display, check the cable
and connecting equipment. If changes are
made, power the unit off and then on again
to reset.
▼ Use of the optional AUI on Port 1 will negate
the ability to use the RJ45 for that port.
▼ If the Link/Duplex LED for a port is not lit,
please check the cable being used. The
port will only be operational if the LED is
green (Good Link/Half Duplex) or yellow
(Good Link/Full Duplex).
Power Requirements
The Lantronix LMS8-A is shipped with either a
120VAC (-01 version) or a 220VAC (-02 version)
power supply. Input power requirements are 15
volts at 1.0 Amps.
CAUTION:
Not for installation in air ducts or plenums
or other environmental air handling spaces.
Changes or modifications to this device not
explicitly approved by Lantronix will void the
user’s authority to operate this device.