Filter
Top Products
ATX6 Installation and User Guide
Page 7
Date/Time Set-Up:
To enter the Date/Time Set-Up Mode, simultaneously press the Center
(NXT) and Right (SET) buttons for 1 second. You will see the Password
prompt: “P000”. For each of the following parameters to be set, the
display will show the parameter number in the two left digit positions,
and the parameter value in the two right digit positions. The
parameters are as follows:
P Awaiting Password (000 ~ 999)
If you have not previously changed the password, press the SET button
to continue [Default Password is ‘000’]. If you have previously changed
the Password, enter the value using the INC, NXT and SET buttons. The
INC button will increment the digit over the displayed cursor. The NXT
button will move the cursor to point to the next digit. The SET button
will enter your final selection. If correct, the display will advance to
enter the first set-up parameter.
If incorrect, an “Err” message will be displayed. Press the Set button
to re-enter your password. Press Inc or Next to abort the setup.
1 Month (01 ~ 12)
Use the INC button to advance through the values. Press the SET button
when the correct value is displayed.
2 Date (01 ~ 31)
Use the INC button to change the first digit. Press NXT to move the
cursor to the next digit, then press INC to change the selected digit.
Press the SET button when the correct value is displayed.
If an incorrect value is entered “Err2” will be displayed. Press the Set
button and reenter the date
3 Year (00 ~ 99)
Use the INC button to change the value of the first digit. Press NXT to
move the cursor to the next digit, then press INC to change the
selected digit. Press the SET button when the correct value is
displayed.