Filter
Top Products
13 - LT Series Operations Manual
CHANGING THE PLATEN
1. Disconnect the power source.
2. Remove the top cover. Remove the frame
locking pin and lift the top frame. Remove
the ribbon (see Changing the Ribbon, Page
11).
3. Lift the printing platen assembly up and out
of the frame. (Fig. 10)
4. Insert the alternate printing platen assembly,
using the guide pin for alignment.
5. Replace the ribbon. Close the top frame and
install the frame locking pin. Install the top
cover.
6. Connect the power source.
7. Make a sample registration. Reset the time
type wheels and the digital display.
Figure 10